NETGEAR CG814WG V3 manual Settings for WEP encryption are shown on the screen

Wireless Cable Modem Gateway CG814WG v3 Reference Manual

Settings for WEP encryption are shown on the screen:

Figure 2-3

4.Select the Authentication. Choose Open System, Shared Key, or Open System or Shared Key. The default is Open System.

5.Enter the encryption settings:

•WEP PassPhrase: To use a passphrase to generate the keys, enter a passphrase and click Generate. This automatically creates the keys. Wireless stations must use the passphrase or keys to access the gateway.

•Key 1-Key4:You can manually enter the four data encryption keys. These values must be identical on all computers and access points in your network. Enter ten hexadecimal digits (any combination of 0-9, a-f, or A-F).

•Select which of the four keys will be the default. Data transmissions are always encrypted using the default key. The other keys can only be used to decrypt received data. The four entries are disabled if WPA-PSK or WPA authentication is selected.

6.Click Apply to save your settings.

Note: If you use a wireless computer to configure WEP settings, you will be disconnected when you click Apply. Reconfigure your wireless adapter to match the new settings or access the gateway from a wired computer to make any further changes.

Wireless Configuration 2-9

v1.0, June 2007