NETGEAR MA101 manual Certificate of the Manufacturer/Importer

Page 65

Certificate of the Manufacturer/Importer

It is hereby certified that the Model MA401 Wireless PC Card has been suppressed in accordance with the conditions set out in the BMPT- AmtsblVfg 243/1991 and Vfg 46/1992. The operation of some equipment (for example, test transmitters) in accordance with the regulations may, however, be subject to certain restrictions. Please refer to the notes in the operating instructions.

Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right to test the series for compliance with the regulations.

VCCI Statement

This equipment is in the Class B category (information equipment to be used in a residential area or an adjacent area thereto) and conforms to the standards set by the Voluntary Control Council for Interference by Data Processing Equipment and Electronic Office Machines aimed at preventing radio interference in such residential areas. When used near a radio or TV receiver, it may become the cause of radio interference. Read instructions for correct handling.

Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice

NETGEAR MA101 Wireless USB Adapter

Tested to Comply with FCC Standards

FOR HOME OR OFFICE USE

Warning!

To comply with the FCC’s rf exposure requirements you must maintain a distance of at least 1 cm from the anten- na of this device while it is in use. This device should not be co-located with other transmitters.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

‹Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna, (2) Increase the separation between the equipment and receiver, (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected, (4) Consult the dealer or an experienced radio/TV technician for help.

Page 64 Page 66
Image 65
Page 64 Page 66
Contents NETGEAR, Inc Technical Support Contents Index Bold times roman User input Preface About This Installation GuidePage Chapter Introduction About the MA101 802.11b Wireless USB AdapterKey Features and Related Netgear Products Model MA101 Resource CD, including What’s in the Box?Road Map for How to Get There From Here Road Map for ‘How to Get There From Here’A Road Map for How to Get There From Here Up the MA101 Other computers Connect to Password that have been Help Network Page What You Will Need Before You Begin Chapter Installing MA101 802.11b Wireless USB AdapterObserve Location and Range Guidelines Verify System RequirementsTwo Basic Operating Modes MA101 Default Wireless Configuration Settings MA101 802.11b Wireless USB Adapter in Infrastructure Mode Connect the MA101 USB Adapter to your computer Setting Up the MA101 in Infrastructure ModeFor Windows XP Users Installing a MA101 Install the MA101 driver software Verify wireless connectivity to your network Insert the Model MA101 Resource CD into your computer For Windows 98/Me Users Installing a MA101Install the MA101 software Click Yes when asked if you want to reboot the system Ssid Wireless Configure your wireless adapterInsert the Model MA101 Resource CD into your CD-ROM drive For Windows 2000 Users Installing a MA101Page MA101 Configuration Utility MA101 802.11b Wireless USB Adapter in Ad-Hoc Mode Using the MA101 to Connect in Ad-Hoc ModeSet up the MA101 USB Adapter for your computer Setting Up a MA101 in Ad-Hoc ModeConfigure your wireless adapters Computer-to-computer Ad-Hoc networks onlyVerify wireless connectivity between the computers Color Condition Description Interpreting System Tray Icon ColorsSymptom Cause Solution Troubleshooting TipsPage Enabling Basic Wireless Security Features Protecting Your Wireless ConnectionPage Changing the Ssid Setting the Wireless Network Name SsidConfiguring WEP Encryption Configuring WEP Encryption SecurityDsss Appendix a Technical SpecificationsPage Related Publications Wireless Networking Appendix B 802.11b Wireless Networking BasicsAd Hoc Mode Peer-to-Peer Workgroup Wireless Network ConfigurationAuthentication and WEP Encryption Extended Service Set Identification EssidWired Equivalent Privacy WEP Wireless Channel SelectionRadio frequency channels used are listed in Table Page Preparing Your Computers for TCP/IP Networking Appendix C Preparing Your PCs for Network AccessInstall or Verify Windows Networking Components Configuring Windows 98 and Me for TCP/IP NetworkingPage Page Primary Network Logon is set to Windows logon Choose Settings, and then Control PanelLocate your Network Neighborhood icon Page Verifying TCP/IP Properties Configuring Windows 2000 or XP for TCP/IP NetworkingDhcp Configuration of TCP/IP in Windows XP Dhcp Configuration of TCP/IP in Windows XP orConnection with the wireless icon and choose Status TCP/IP details are presented on the Support tab Dhcp Configuration of TCP/IP in Windows Page Verifying TCP/IP Properties for Windows XP or Page Numerics IndexPage Page Page Certificate of the Manufacturer/Importer Page NETGEAR, Inc
Top Page Image Contents