NETGEAR GS724T-300NAS manual Checking the Installation

Page 20

GS716T/GS724T Hardware Installation Guide

5.Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack.

Figure 4-1

Step 3: Checking the Installation

Before applying power perform the following:

•Inspect the equipment thoroughly.

•Verify that all cables are installed correctly.

•Check cable routing to make sure cables are not damaged or creating a safety hazard.

•Ensure all equipment is mounted properly and securely.

Installation

4-15

v1.0, January 2011

Image 20

Contents GS716T/GS724T Hardware Installation Guide NETGEAR, IncTrademarks Contents Appendix B Technical Specifications Index About This Manual Conventions, Formats and ScopeRevision History Chapter Introduction OverviewFeatures Package Contents GS716T/GS724T Hardware Installation Guide System LEDs 10/100/1000 Mbps Ethernet Ports SFP Ports GS716T Front and Back Panel ConfigurationChapter Physical Description GS724T Front and Back Panel Configuration RS-232 Power ConnectorLED Designations Port LEDsPort DesignationRJ-45 Ports Device Hardware InterfacesSystem LEDs Factory Defaults Button SFP Gbic ModuleDesktop Switching Chapter ApplicationsApplications Preparing the Site Chapter InstallationCharacteristics Requirements Installing the Switch in a Rack Installing the SwitchInstalling the Switch on a Flat Surface Checking the Installation Connecting Devices to the Switch Installing an SFP Gbic ModuleApplying AC Power Managing the Switch using a Web Browser or the PC Utility Symptom Cause Solution Appendix a TroubleshootingTroubleshooting Chart Additional Troubleshooting Suggestions ConfigurationSwitch Integrity Network Adapter CardsAuto-Negotiation Appendix B Technical Specifications Network Protocol and Standards CompatibilityManagement InterfacePerformance Specifications Power SupplyPhysical Specifications Environmental SpecificationsModules Index NumericsGS716TGS724T Hardware Installation Guide Index-29