NETGEAR DS108, DS116, DS106, DS104 manual Connect a PC to the Hub, Set Normal/Uplink Push Button

Page 9

Connect a PC to the Hub

Power

Collision

Normal/Uplink

9097FA

Set Normal/Uplink Push Button

The Normal/Uplink push button on the front panel of the hub allows you to select the Uplink (MDI) or Normal (MDI-X) position for port 4 on the Model DS104 hub, port 6 on the Model DS106 hub, port 8 on the Model DS108 hub, and port 16 on the Model DS116 hub. All other ports are wired Normal for direct connection to PCs.

Select Normal if connecting a PC, server, or router to the port. Select Uplink if connecting a hub or switch. The Normal/Uplink push button eliminates the need to use a crossover cable.

Caution: 100 Mbps operation requires the use of Category 5 UTP wiring with 100 Mbps certified connectors. NETGEAR highly recommends using Category 5 cable so your network can operate at either 10 or 100 Mbps.

Model DS104/DS106/DS108/DS116 Dual Speed Hub Installation Guide

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Page Start Here FeaturesPackage Contents Typical Applications Front-Panel LEDs Product IllustrationModel DS104, Model DS106, and Model DS108 LEDs Model DS116 LEDsLabel Color Activity Description Vista RJ-45 Network Ports with Built-in LEDs Rear PanelLED Status Description Install the Hub Installation Procedures Prepare the SiteInstall the Hub on a Flat Surface Install the Hub on a WallSet Normal/Uplink Push Button Connect a PC to the Hub10 or 100 Mbps Transmission with the Hub Connect Hubs at 10/100 MbpsVerify the Installation Troubleshooting InformationSymptom Cause Solution Power Specifications Technical SpecificationsReplacement Power Adapter Order code DS104, DS106, DS108Order code DS116 Trademarks DS100NA-3
Top Page Image Contents