NETGEAR DS508 manual Site Preparation, Rear Panel

vista RJ-45

network ports

100M

10M

8152FA

Rear Panel of the Model DS508, Model DS516,

and Model DS524 Hubs

Cascade Up connector
Terminator LED
10/100 Mbps Bridge LED	Power receptacle

Cascade Up
Cascade Down	10/100 Mbps
	Terminator	Bridge
		100-240 VAC 50-60 Hz 0.5A

Cascade Down connector

8153FA

Rear Panel

The rear panel of a Model DS508, Model DS516, and Model DS524 hub has two LEDs, one labeled Terminator and one labeled 10/100 Mbps Bridge. The Terminator LED indicates whether or not the built-in terminator in that hub is active (the built-in terminator eliminates the need for an external terminator). The 10/100 Mbps Bridge LED indicates which hub has the active bridge.

Site Preparation

Before you begin installing the hubs, prepare the installation site. Make sure your operating environment meets the operating environment requirements of the equipment.

Characteristic	Requirement
Temperature	Ambient temperature between 0° and 40° C
	(32° and 104° F). No nearby heat sources such as
	direct sunlight, warm air exhausts, or heaters.
Humidity	90% maximum relative humidity, noncondensing.
Ventilation	Minimum 2 inches (5.08 cm) on all sides for cooling.
	Adequate airflow in room or wiring closet.
Operating	At least 6 feet (1.83 m) to nearest source of electromagnetic noise (such as
conditions	photocopy machine
	or arc welder).
Service access	Minimum 12 inches (19.68 cm) front and back for service access and
	maintenance.
	Front and back clearance for cables and wiring hardware such as punchdown
	blocks.
Power	Adequate power source within 6 feet (1.83 m).
Tabletop	Flat area approximately 13.0 inches (33.0 cm) by
requirements	8.0 inches (20.3 cm).

Model DS508/DS516/DS524 Dual Speed Stackable Hub Installation Guide