Installation Procedures
Install the Hub
Install the Hub on a Flat Surface
If installing the hub on a flat surface such as a tabletop, make sure the bottom of the chassis is clean and dry and allow at least 2 inches of space on all sides of the hub to ensure proper ventilation.
1.Install the
2.Set the hub on a table or shelf so that it has at least 2 inches (5 cm) of space on all sides.
3.Connect the power cord(s) first to the power entry receptacle on the hub rear panel and then to the wall.
Install the Hub in a Rack
To install the hub in a rack, make sure you have #2 and #3 Phillips screwdrivers. Refer to the illustration and follow the steps.
#3 Phillips | screwdriver | #2 Phillips | screwdriver |
(use large | screws with spacers) | (use small screws) | |
|
| 1 |
|
|
|
|
Power | Data Collision | Link |
| 5 |
|
|
| RX |
|
| |||
|
| 13 |
| Link |
|
|
|
|
|
| RX |
| |
|
|
|
| 17 | Link | 12 |
|
|
|
|
| RX | |
|
|
|
|
|
| Normal/Uplink |
|
|
|
|
|
| 24 |
8145FA
1.Attach the mounting brackets (supplied in the rack mount kit) to the sides of the hub using the screws provided.
2.Attach the hub (with the mounting brackets) to the rack using two panhead screws with nylon washers.
Model DS508/DS516/DS524 Dual Speed Stackable Hub Installation Guide