NETGEAR GS700AT Series manual Checking the Installation

GS700AT Hardware Installation Guide

5.Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack.

Figure 2-1

Note: Always install devices from the bottom of the to the top. This will prevent the rack from over balancing and toppling over.

Step 3: Checking the Installation

Before applying power perform the following:

•Inspect the equipment thoroughly.

•Verify that all cables are installed correctly.

•Check cable routing to make sure cables are not damaged or creating a safety hazard.

•Ensure all equipment is mounted properly and securely.

Installation 2-3

v1.0, October 2008