NETGEAR FS 726, FS 750 manual LED Mode Button and LED Descriptions, Front Panel LEDs

LED Mode Button and LED Descriptions

LEDs on the front panels of the FS726 and FS750 Switches provide a quick and accurate display of port operation. Users can clearly identify the status of each port for link and by toggling the LED Mode button through the associated categories speed, activity, collision, and duplex mode .

Table 2-1 summarizes the LEDs on the FS726 and FS750 Switches. A detailed description of the LEDs follows the table.

Table 2-1. Front Panel LEDs
Label	Color	Activity	Description
Power	Green	On	Power is supplied to the switch.
	Off		Power is disconnected
Link	Green	On	Port has a valid link connection.
	Off		A valid link has not been established on the port.
Mode in: Max Spd
10/100 Mbps Port	Green	On	Port has made a 100 Mbps connection.
		Off	Port has made a 10 Mbps connection.
Module Bay Port	Green	On	Port has a valid 1000 Mbps (1 Gbps) link connection
		Off	A valid link has not been established on the port.
Mode in: Activity /
Collision	Green	Blinking	Data transmission is occurring on the port.
	Yellow	Blinking	Data collision is occurring on the port. The rate at
			which this LED blinks corresponds to the number of
			collisions. When a collision occurs, the connected
			device pauses and transmits again after waiting a
			specified time.
Mode in: FDX	Green	On	Port is operating in full-duplex mode.
	Yellow	On	Port is operating in half-duplex mode.

physical description 2-4