NetComm NP6800 manual Connecting to the Access Point using the Snmp Manager

Connecting to the Access Point using the SNMP Manager

1.Open Start->Programs->802.11 Wireless LAN->Acess Point Utility and click on SNMP Manager. There are two ways to connect to the NetComm NP6800 - Wireless LAN Access Point with the AP Utility:

■ Select File -> Connect to Access Point option and enter the IP and the Community.

■Select File -> Find Access Point option. After a while a window will display any Access Point devices that the Utilty has found.

Note: If the Access Point is found and displayed but you can not connect to it, you will need to temporarily change your computer’s IP address. Refer to the section on Assigning a temporary IP Address for further information.

2.From that window you can select the Access Point that you want to configure and click the connect button. The Connect to Access Point window will appear with the correct IP address displayed. Enter the Community in order to get access to the functionality of the NetComm NP6800 - Wireless LAN Access Point.

Rev.1 - YML655	www.netcomm.com.au
NP6800 - Wireless LAN Access Point	Page 19