NetComm AM5698 manual Regulatory Information, Austel Requirements Australia Only

Page 32

Regulatory Information

Austel Requirements (Australia Only)

The software supplied with this modem has default settings compliant with the requirements of Austel Technical Standard TS-ØØ2.

Adjustment of these settings outside the required limits will void the Austel permit associated with the modem.

Dial Retry Attempts

With the service tone detection enabled (eg. Busy Tone) the unit must not be configured to make more than 1Ø dial attempts to the same telephone number.

With the service tone detection disabled (eg. Busy Tone - ATXØ) the unit must not be configured to make more than 3 dial attempts to the same telephone number.

With dial tone detection disabled (eg. ATXØ) the unit should be configured to dial not less than two seconds after line seizure and not more than 5 seconds after line seizure.

In all of the above cases no further attempts shall be made to connect to the telephone number, until a further period of at least 3Ø minutes has elapsed (this does not apply if the redial sequence is manually restarted).

Call Answering

The modem shall answer an incoming call by seizing the line in not less than 2 seconds from the start of the application of ring signal from the PSTN. (eg. ATSØ=2 or issue ATA after the 2nd ring.)

Internal Modems Internal modems are designed to operate only within a PC with a screw down lid.

Also, telecommunications network voltages exist on the card inside the PC. Therefore the

telecommunications line connection (Telecom cable) must be removed before opening the case of the PC. NOTE Adjustment of these settings outside the required limits will void the Austel permit associated with the modem.

Connection of a non-approved modem to the telecommunications network is an offence under Section 253 of the Telecommunications Act 1991 and may attract a maximum fine of $12,ØØØ.

www.netcomm.com.au

Rev.1 - YML658

Page 32

AM5698 Roadster V.92 User Guide

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Page Contents Rev.1 YML658 AM5698 Roadster V.92 User Guide Features of your Roadster V.92 modem Download fasterInstalling your Modem Speakerphone Installing your Drivers Windows XPWindows Rev.1 YML658 AM5698 Roadster V.92 User Guide Windows Me Windows Rev.1 YML658 Windows NT4.0 Rev.1 YML658 Installing your Software Facsimile and Voice Mail UtilityGeneral settings Using your Roadster V.92 Modem with FaxTalkConfiguring voice/fax mailboxes Discarding messages Logging incoming callsAutomatically detecting fax calls Password protecting a mailbox Greeting settingsRecording a greeting Selecting a greetingPlaying a greeting Deleting a greetingSelecting a greeting Placing calls Using the Speakerphone featureReceiving calls Using the phonebook Using the redial listAdjusting the speakerphone volume Adjusting the microphone sensitivityTroubleshooting Testing Your ModemUpdating Your Modems Firmware AT Commands What is V.92? Frequently Asked V.92 QuestionsDoes V.92 QuickConnect work on all calls? Registering your Modem Contact Information Warranty Registration Form Page Warranty Information Limitations of WarrantyRegulatory Information Austel Requirements Australia OnlyTelecom New Zealand Important NoticeMandatory European Statement Network Compatibility StatementFCC Class B Certification CE Mark Warning
Top Page Image Contents