Multi-Tech Systems MT202TD 1200 Appendix Regulatory Compliance, FCC Part 15 Class a Statement

Page 23

Appendix

Appendix - Regulatory Compliance

FCC Part 15 – Class A Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Industry Canada

This Class A digital device meets all requirements of the Canadian Interference Causing Equipment Regulations.

Cet appareil numerique de la classe A respecte toutes les exigences du Reglement Canadien sur le materiel brouilleur.

23

Image 23
Contents BPS Leased Line Modem User Guide Model MT202TDCopyright Contents Appendix Regulatory Compliance Introduction & Description Introduction and DescriptionTechnical Specifications Operating Temperature ConnectorsDiagnostics IndicatorsIntroduction Installation and ConnectionPower Safety WarningsUnpacking the Modem Installation & ConnectionCTS Modem LED IndicatorsPC Board Controls Controls on PC BoardComputer or Terminal Connections Pin MT202TD RS-232 Signal DescriptionsCircuits Function Signal Name EIA ITU-T Source Modem and Phone Line Connection Installation StepsRemoving Screws DIP Switch SettingsSee Figure DIP Switch and Switch Settings & FunctionsLeased Line Connections Four-Wire Leased Line ConnectionLocal Analog Loopback Test Modem TestingDigital Loopback Test Modem TestingOnline Warranty Registration Limited WarrantyMulti-Tech Systems, Inc Woodale Drive Mounds View, MN ServiceWarranty, Service & Technical Support Recording Modem Information Technical SupportInternet Sites Industry Canada Appendix Regulatory ComplianceFCC Part 15 Class a Statement AppendixFCC Part 68 Telecom RJ11C MT202TD User Guide IndexPage 82096502