Multi-Tech Systems ISI5634UPCI, ISI9234PCIE Verifying Successful Loading of the Linux Driver

ISI Quick Start Guide

Verifying Successful Loading of the Linux Driver

1.To confirm the successful loading of the driver, execute the command "lsmod". The driver "mtsi_upci" should be listed in the list of modules. If the driver is not listed, invoke the "lsmod" command again and watch for errors.

2.Check that the tty devices (with names of the form "ttyMUxy") are listed under the /dev directory. If the tty devices are not listed, invoke the ". /mknod_script" command again (it was previously run as part of the "make install" script in step 7 of the "Building the Linux Driver" procedure) and watch for errors.

3.To confirm that the tty devices function for each modem on the ISI card, execute the utility "minicom" and dial out on each modem.

Un-Installing the Linux ISI Driver

1.Run the "make clean" script. You must run this command from the "mtsi_upci_driver" directory.

The "make clean" script will delete the "resetport" and "mtsi_upci.o" files.

2. Run the "make uninstall" script.

You must run this command from the "mtsi_upci_driver" directory. The "make clean" script will remove the module "mtsi_upci".

3.Execute the "lsmod" command. The "mtsi_upci" module should no longer be listed. If this module is still listed, then invoke the command "rmmod mtsi_upci" and check again to see whether or not the module is listed.

4.Delete serial ports (these are files with names of the form "ttyMUxy"). To do so, go to the "dev" directory.

Enter the command "rm ttyMUZ".

Using the Linux Port Reset Utility

For the serial cards, the port-reset utility allows you to reset ports without rebooting. For the modem cards, the port-reset utility allows you to reset both ports and modems without rebooting.

To reset a serial port, the DTR pin is set to the low logic level for one second. To reset the modem port, the Reset pin is toggled (i.e., its logic state is inverted and then restored).

1.To reset the port (for serial card) or modem (for modem card) run the command "resetport /dev/ttyMUxy"

(where 'x' stands for card number and 'y' for the port number).

2.On the serial cards, the DTR LED will toggle indicating that the reset has occurred and this toggling might be observable on the modem attached to the port (if the modem is equipped for this indication). There is no similar indication of successful reset on the modem cards.

15