Multi-Tech Systems F2 manual Installation Instructions for Hazardous Locations, Vehicle Safety

Page 5

Chapter 1 – Product Description and Specifications

Installation Instructions for Hazardous Locations

1.The modems are open devices intended for installation in an ultimate enclosure suitable for the intended application.

2.THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I, DIVISION 2, GROUPS A, B, C, AND D OR NON- HAZARDOUS LOCATIONS ONLY.

3.“WARNING – Explosion Hazard – Substitution of Components may Impair Suitability for Class I, Division 2”.

4.“WARNING – Explosion Hazard – Do not Disconnect Equipment Unless Power has been switched off or the area is known to be Non-hazardous”.

5.“WARNING – Explosion Hazard – Do not replace fuse unless power has been switched off or the area is known to be non-hazardous”

6.“WARNING – Do not install or remove SIM card unless power has been switched off or the area is known to be non-hazardous”.

Vehicle Safety

Do not use your MultiModem while driving.

Respect national regulations on the use of cellular telephones in vehicles. Road safety always comes first.

If incorrectly installed in a vehicle, the operation of Wireless MultiModem telephone could interfere with the correct functioning of vehicle electronics. To avoid such problems, be sure that qualified personnel have performed the installation. Verification of the protection of vehicle electronics should be part of the installation.

The use of an alert device to operate a vehicle’s lights or horn on public roads is not permitted.

Maintenance of Your Modem

Your Wireless MultiModem is the product of advanced engineering, design, and craftsmanship and should be treated with care. The suggestions below will help you to enjoy this product for many years.

Do not expose the Wireless MultiModem to any extreme environment where the temperature is above 50ºC or humidity is above 90% noncondensing.

Do not attempt to disassemble the Wireless MultiModem. There are no user serviceable parts inside.

Do not expose the Wireless MultiModem to water, rain, or spilled beverages. It is not waterproof.

Do not place the Wireless MultiModem alongside computer discs, credit or travel cards, or other magnetic media. The phone may affect the information contained on discs or cards.

The use of accessories not authorized by Multi-Tech or not compliant with Multi-Tech's accessory specifications may invalidate the warranty of the Wireless MultiModem.

In the unlikely event of a fault in the Wireless MultiModem, contact Multi-Tech Tech Support.

Your Responsibility

This Wireless MultiModem is your responsibility. Please treat it with care respecting all local regulations. It is not a toy. Therefore, keep it in a safe place at all times and out of the reach of children.

Try to remember your Unlock and PIN codes. Become familiar with and use the security features to block unauthorized use and theft.

Package Contents

Unbundled Package:

Bundled Package:

Modem and No Accessories

Modem and Accessories

1 modem

1 modem

1 mounting bracket

1 mounting bracket

1 fused DC power cable

1 antenna

1 Quick Start Guide

1 serial cable

1 MultiModem CD

1 power supply (type depends on regional in which it will be used)

 

4 rubber feet for flat surface mounting

Note: You must supply bracket screws

1 Quick Start Guide

and an antenna.

1 MultiModem CD

 

Note: You must supply bracket screws.

Part to be Supplied by Wireless Service Provider

Subscriber Identity Module (SIM) configuration chip. The SIM contains information specific to your wireless account and its features.

Multi-Tech Systems, Inc. MultiModem GPRS Wireless Modem User Guide

5

Image 5
Contents MultiModem Gprs S000304M, Revision M Copyright MultiModem Gprs User Guide Wireless ModemRevision History Revision Date Description Trademarks and LogosContents Safety Product Description SpecificationsGeneral Safety RF Interference IssuesVehicle Safety Installation Instructions for Hazardous LocationsMaintenance of Your Modem Package ContentsFunctions GSM Modes SpecificationsMode Description Antenna/RF Specifications Electrical CharacteristicsAT Command Information RS232 15-Pin Connector PinoutInterfaces LEDsInsert the SIM Card into the Holder Activation InstallationActivate Your Wireless Account Antenna Hook up the Antenna, Serial Cable, and PowerPower Optional Attach the Modem to a Flat Surface Verifying That Your Modem Has Been Installed Successfully Install the Modem DriverIntroduction RequirementsExamples of Useful AT Commands Using Your Wireless ModemPhone Numbers for the Wireless Modem Establishing a Voice Call Establishing a Circuit-Switched Data CSD ConnectionAnswering a Circuit-Switched Data CSD Connection Using Short Message Services SMS Send an SMS message to another SMS compatible device SMS ExamplesUsing Your Wireless Modem Connecting to the Gprs Network for Internet Access Internet AccessCreate Your Dial-Up Connection in Windows XP/2003 Disconnecting the ConnectionMobile PhoneTools Troubleshooting Examples Troubleshooting Frequently Asked QuestionsSolutions for ‘no connection through serial link’ situation Solutions for no carrier messageFrequently Asked Questions How do I send an SMS message to an email account? Reference Information Wireless Modem Reference InformationData Cable Diagram No Voice Reference Information Multi-Tech Warranty Statement Appendix a Warranty and RepairsRepair Procedures for U.S. and Canadian Customers Repair Procedures for International CustomersReplacement Parts Repair Procedures for International DistributorsJuly
Related manuals
Manual 29 pages 52.82 Kb