MicroNet Technology SP3508A manual Port Controls, Speed, Duplex

Page 22

5.6Port Controls

This section shows user how to change every port status and speed mode. The procedure that the VDSL Switch determines speed is as follows:

1.Confirm the phone cable have been connected with SP3508A and SP3501AS.

2.Power on both devices.

3.The device will start auto-speed function after SP3501AS re-boot.

4.SP3508A will try 25M mode to link with SP3501AS, if fail, auto speed down to 15M mode and re-link with SP3501AS. If fails again, auto- speed down to 5M and keep this mode then re-link with SP3501AS.

5.Please note any change of phone cable, SP3508A must powered off and on, due to auto-speed function only work on re-starting.

6.Await 5 ~ 120 seconds until VDSL port link up depend on length of phone cable.

Parameter	Description
State	Users can disable or enable VDSL port activity.
Auto Negotiation	Users can disable and enable auto negotiation for the VDSL ports.
Speed	Users can change the speed of each VDSL port.
Duplex	User can set full-duplex or half-duplex mode of Ethernet port. VDSL
	ports are fixed at full-duplex.
Flow Control	Full: User can set flow control function is enable or disable in full
	mode.
	Half: User can set backpressure is enable or disable in half mode.

19

Image 22

Contents User’s Manual Port Vdsl Managed SwitchModel No. SP3508A Table of Contents Chapter Application Appendix Key Features Package ContentsIntroduction Page Pre-installation Requirements InstallationHardware Installation Cabling RequirementsConnecting to Gigabit Ethernet Vdsl Port RJ-11Connecting to RJ-11 10/ACT Physical DescriptionLED Definition 100/ACTGigabit Switch ConnectorsEthernet Out-Band Access IP Address ConfigurationConsole Port Program will enter the following text-based user interface Previous Menu EditSave Main MenuTelnet Remote AccessWeb-Based UI Page Home Web-Based UI Management InterfacePort Status Port Statistics IP Address Switch SettingBasic Advanced Enable Delay Bound First Come First ServiceWeighted Round Robin Broadcast Storm FilterProtocol Enable Spanning TreeEnable Internet Group Multicast Protocol Vlan ProtocolSpeed Port ControlsDuplex System Priority Aggregator SettingLink Aggregation Group IDAggregator Information State ActivityActive Filter DatabaseIgmp Snooping PassiveStatic MAC Address Port Security MAC FilteringVlan Configuration Support Multiple Vlan Ieee 802.1Q VlanSupport Protocol-based Vlan Ingress Filtering Port VIDIngress Filtering Rule Spanning Tree Max Age Delay TimePriority Hello TimePort Priority Port SnifferPath Cost Snmp Contact NameLocation Read only‘Fan Speed Alarm’ trap Signal to Noise Ratio‘Temperature Alarm’ trap Security ManagerReconfirm Password Tftp Update FirmwarePassword UsernameTftp Restore Configuration Configuration BackupTftp Backup Configuration Reset Reset and Rebooting SystemReboot Application Bridging FunctionsAppendix a Specifications AppendixDimension Appendix B Troubleshooting Installation Appendix C System DiagnosticsPower and Cooling Problems Transmission ModeCabling Physical ConfigurationSystem Integrity Appendix D Vdsl Spectrum Vdsl Technology Requirements & DefinitionsAppendix E Example of Vlan Setting Port-Based Vlan SettingTag-Based Ieee 802.1Q Vlan Setting Page Page