DTIM | Determines the interval the Access Point will send its | |
broadcast traffic. The range is from 1 to 255 and the default | ||
| value is 3 beacons. | |
| 802.11b – It only allows 802.11b wireless network client to | |
| connect to this router (maximum transfer rate 11Mbps). | |
| 802.11g – It only allows 802.11g wireless network client to | |
| connect to this router (maximum transfer rate 54Mbps). | |
| 802.11b+g – It only allows 802.11b and 802.11g wireless | |
| network client to connect to this router (maximum transfer rate | |
| 11Mbps for 802.11b clients, and maximum 54Mbps for | |
| 802.11g clients). | |
| 802.11n – It only allows 802.11n wireless network client to | |
| connect to this router (maximum transfer rate 300Mbps). | |
| 802.11g+n – It allows 802.11g, and 802.11n wireless network | |
Wireless Mode | client to connect to this router (maximum transfer rate | |
54Mbps for 802.11g clients, and maximum 300Mbps for | ||
| ||
| 802.11n clients). | |
| 802.11b+g+n – It allows 802.11b, 802.11g, and 802.11n | |
| wireless network client to connect to this router (maximum | |
| transfer rate 11Mbps for 802.11b clients, maximum 54Mbps | |
| for 802.11g clients, and maximum 300Mbps for 802.11n | |
| clients). | |
| NOTE: For 802.11b and 802.11g mode, the signals can be | |
| transmitted only by antenna 1 (The antenna in the right side | |
| of the rear panel). | |
| For 802.11n mode, the router is operating in a 2T3R Spatial | |
| Multiplexing MIMO configuration. 2 antennas are for signal | |
| transmitting and 3 antennas are for signal receiving. |
11n Settings
| Parameter |
| Description |
|
|
|
|
| Channel Bandwidth |
| Set channel width of wireless radio. Do not modify default |
|
| value if you don’t know what it is, default setting is ‘20/40 | |
|
|
| MHz’. |
| Extension Channel |
| Select the extension channel to above or below the control |
|
| channel while 40MHz channel bandwidth is selected. Do not | |
|
|
| |
|
|
| modify the default value if you don’t know what it is. |
| Guard Interval |
| It is one of several |
|
| efficiency. Select 400nsec to provide a shorter delay between | |
|
|
| transmission frames in 11n network. The throughput in |
|
|
| 400nec guard interval is better than 800nsec guard interval. |
|
|
| Select MCS |
| MCS |
| When MCS 15 is selected, the data rate is up to 300Mbps. It |
|
| is recommended to set “Auto” and the router will negotiate | |
|
|
| |
|
|
| with wireless clients to operate in a proper data rate. |
| SSID Index |
| This router can support multiple SSIDs. By default, this |
|
| function is disabled. | |
|
|
| |
|
| 27 |