Milan Technology MIL-SM801XX manual Resetting Factory Defaults, Usage loaddefault

Page 18

Figure 3-8. After pressing Enter twice, the first secured IP address is set to 199.86.12.46.

You can reset the switch back to factory default settings by using the loaddefault command. Simply type L 2 at the MIL>_ prompt and press enter.

Note: If you do not type L 2, and only type L, the following option appears:

The only correct option is L 2 for the MIL-SM801XX.

Image 18

Contents MIL-SM801xx Page Regulatory Approval Contents Introduction MIL-SM801XXFeatures Intelligent Management FeaturesPackage Contents Ethernet Switching Technology Package ContentsWeb-based Management Management MethodsConsole and Telnet Management Snmp Network ManagementHardware Description Front PanelLED Indicators Front Panel of the MIL-SM801XX with MT-RJ connectorPower 100M Rear PanelDesktop Installation Attaching Rubber FeetNetwork Configuration Connecting the MIL-SM801XX to a terminal via RS-232 cableAssigning an IP Address to the switch MIL ip-address MIL 2Page Execute reboot Secured IP Resetting Factory Defaults Usage loaddefaultSystem Login Web-Based ManagementClick Login button, then the Password Dialog Box appears Network Setting System GroupStatistics StatisticsPort Configuration Speed Config Speed ConfigVlans Trunking TrunkingAgent Config Agent ConfigBoot Methods Dimensions Specifications Standards ComplianceLED Indicators WeightDiagnosing LED Indicators Incorrect connectionsCabling Appendix Browser Settings Page Page Page Page 90000374B