Milan Technology MIL-SM801XX manual Boot Methods

Page 28

Boot Methods

There are three modes that you can boot your switch in ---

FLASH Boot – Boots from a memory chip that software images can be stored, booted, and rewritten as necessary. Flash memory resides in a chip and holds its content without power.

BootP - Boots your system from a BootP (Bootstrap Protocol) server. BootP is a TCP/IP protocol used by a diskless workstation or network computer to obtain its IP address and other network information such as server address and default gateway.

DHCP Boot – Boots your system from a DHCP (Dynamic Host Configuration Protocol) server. DHCP servers can automatically assign IP addresses to client stations logging onto a TCP/IP network.

The following are the initial factory values. You can change the information by entering new information. (For example, you can change the MIL-SM801XX’s IP address by directly typing in new IP address.) Then click Apply after entering the information.

Boot-Method: flash

IP address: 193.31.103.7 (192.168.1.77)

Submask: 255.255.255.0

Broadcast: 255.255.255.255

Gateway: 192.168.1.6

Trap1: 0.0.0.0

Trap2: 0.0.0.0

Trap3: 0.0.0.0

Trap4: 0.0.0.0

GetCommunity: public

SetCommunity: public

TrapCommunity: public

Telnet/HTTP-Username: root

Telnet/HTTP-Password: root

Secured_IP1: 0.0.0.0

Secured_IP2: 0.0.0.0

Secured_IP3: 0.0.0.0

Remember to click the Reboot Agent button for changes to take effect.

Note: SNMP traps are only sent after a cold start.

24

Image 28
Contents MIL-SM801xx Page Regulatory Approval Contents Introduction MIL-SM801XXIntelligent Management Features FeaturesPackage Contents Ethernet Switching Technology Package ContentsManagement Methods Console and Telnet ManagementWeb-based Management Snmp Network ManagementHardware Description Front PanelLED Indicators Front Panel of the MIL-SM801XX with MT-RJ connectorPower 100M Rear PanelDesktop Installation Attaching Rubber FeetNetwork Configuration Connecting the MIL-SM801XX to a terminal via RS-232 cableAssigning an IP Address to the switch MIL ip-address MIL 2Page Execute reboot Secured IP Resetting Factory Defaults Usage loaddefaultSystem Login Web-Based ManagementClick Login button, then the Password Dialog Box appears Network Setting System GroupStatistics StatisticsPort Configuration Speed Config Speed ConfigVlans Trunking TrunkingAgent Config Agent ConfigBoot Methods Specifications Standards Compliance LED IndicatorsDimensions WeightIncorrect connections Diagnosing LED IndicatorsCabling Appendix Browser Settings Page Page Page Page 90000374B