Milan Technology MIL-S2400, MIL-S1600 Rear Panel, Desktop Installation, Attaching Rubber Feet

Rear Panel

The 3-pronged power plug, On/Off switch, and ventilation fan are located at the rear panel of the MIL- S2400 and MIL-S1600 Switches as shown in Figure 2-2. The Switch will work in the range 100-240V AC, 50-60Hz.

Figure 2-3. The Rear Panel of MIL-S2400 and MIL-S1600 Switches

Desktop Installation

A. Set the Switch on a sufficiently large flat space with a power outlet nearby. The surface where you put your Switch should be clean, smooth, level and sturdy.

B. Make sure there is enough clearance around the Switch to allow attachment of cables, power cord and allow air circulation.

Attaching Rubber Feet

A.Make sure mounting surface on the bottom of the Switch is grease and dust free.

B.Remove adhesive backing from rubber feet.

C.Apply the rubber feet to each corner on the bottom of the Switch.

Figure 2-4. Attach rubber feet to each corner on the bottom of the Switch