![](/images/new-backgrounds/1193456/19345617x1.webp)
Rack-mounted Installation
The
Perform the following steps to rack mount the switch:
A.Position one bracket to align with the holes on one side of the switch and secure it with the smaller bracket screws. Then attach the remaining bracket to the other side of the switch.
Figure 2-4. Attach mounting brackets with screws
B.After attaching both mounting brackets, position the
Figure 2-5. Mount the MIL-S1600 Switch in an EIA standard 19-inch Rack
Note: For proper ventilation, allow about at least 4 inches ( 10 cm ) of clearance on the front and 3.4 inches ( 8 cm ) on the back of the switch. This is especially important for enclosed rack installation.
Power On
Connect the power cord to the power socket on the rear panel of the switch. Connect the other end of the power cord to the power outlet. The internal power supply of the switch works with AC in the voltage range
Check the power indicator on the front panel to see if power is properly supplied.