RS485-CF-01
Provides one (1) terminal block RS- 485/RS-422 copper connector and one (1) set of RX (receive) and TX (transmit) ST 100BASE-FX connectors to multimode fiber @ 850 nM.
RS485-CF-01(SM)
Provides one (1) terminal block RS- 485/RS-422 copper connector and one (1) set of RX (receive) and TX (transmit) ST 100BASE-FX connectors to singlemode fiber @ 1300 nM.
RS485-CF-01(SC)
Provides one (1) terminal block RS- 485/RS-422 copper connector and one (1) set of RX (receive) and TX (transmit) SC 100BASE-FX connectors to multimode fiber @ 850 nM.
RS485-CF-02
Provides one (1) DB-9RS-485/RS-422 copper connector and one (1) set of RX (receive) and TX (transmit) ST 100BASE-FX connectors to multimode fiber @ 850 nM.
RS485/422 to Fiber Media Converter | DB-9 |
Fiber |
RS485-CF-02(SM)
Provides one (1) DB-9RS-485/RS-422 copper connector and one (1) set of RX (receive) and TX (transmit) ST 100BASE-FX connectors to singlemode fiber @ 1300 nM.
RS485-CF-02(SC)
Provides one (1) DB-9RS-485/RS-422 copper connector and one (1) set of RX (receive) and TX (transmit) SC 100BASE-FX connectors to multimode fiber @ 850 nM.
RS485-CF-0x in the Network . | . . . . .2 |
Installation | . . . . .3 |
Operation | . . . . .4 |
Fault Isolation and Correction | . . . . .5 |
Cable Specifications | . . . . .6 |
Technical Specifications | . . . . .7 |
Compliance Information | . . . . .8 |
RS-485/422 CABLE
One slide switch on the RS485-CF-0x series Media Converter allows site selection of RS-485 2-wire (half-duplex) operation, RS-485 4-wire (full- duplex) operation, or RS-422 4-wire (full-duplex) operation (see page 3).
Asecond slide switch on the RS485-CF-0x series Media Converter allows echo prevention in two-wire mode or transmission only on "transmit/receive -
(B) RS-485 2wire, transmit - RS-422 and transmit/receive + (A) RS-485 2wire, transmit + RS-422" pair (see page 3).
A 4-position dip switch on the RS485-CF-0x series Media Converter allows site selection of 130 ohm terminator insertion on the "receive – RS485 4 wire, RS422 and receive + RS485 4 wire, RS422" pair or on the "transmit/receive - (B) RS485 2wire, transmit - RS422 and transmit/receive +
(A) RS485 2wire, transmit + RS422" pair (see page 3.).
The dip switch also allows site selection of 1K ohm pull down on "transmit/receive - (B) RS485 2wire, transmit - RS422" or of 1K ohm pull up on "transmit/receive + (A) RS485 2wire, transmit + RS422” (see page 3).
