Switch 40 to select, Cord 39 to the AC

C O N T R O L S A N D C O N N E C T I O N S

(27)

(28)

(29)

(30)

(31)

(32)

(33)

(34)

(35)

Check the power source for the voltage (115VAC or 230VAC) in your area and switch the Power Selector

switch (40) to select

the proper voltage. Once you have con- nected the AC power

cord (39) to the AC

power source, switch on your mixer with the

Power On switch (36). The Power ON LED

(20)will light up. Allow 1 minute after power- ing up for the system to reach equilibrium before setting input gains and other levels. You can leave the MXE-1212 on all the time. It is conservative- ly designed, so heat build-up isn’t a problem even in 24-hour-a-day operation. There’s nothing that will burn out or get used up. Alternatively, you can just plug every unit in your total system into a

Nady Power Conditioner PCL- 800/810/815 or a good quality power strip, for one-buttonturn-on.

The MXE-1212 is fused for your (and its own) protection. If a fuse blows, disconnect the AC cord, and replace the fuse with a 2.0A (5x20mm, 250V) type, available at elec- tronics stores or through your dealer. If the fuse blows continu- ously upon replace- ment, unplug the unit and refer to qualified personnel for servicing before further use.

(38) PHANTOM POWER SWITCH

(21) PHANTOM POWER ON LED INDICATOR

When using condenser mics, +48VDC can be switched glob- ally on or off to the XLR mic inputs for all six channels (also see MONO INPUT SECTION, MIC INPUTS). When this switch is in the ''ON'' position (button depressed), the Phantom Power On LED Indicator (21) will light, and +48VDC will be provided between pins 2 and 3 of all the Mic input XLR connectors. If you don’t need phantom power, be sure to turn this switch to the ''OFF'' position.

[Note: It is safe to connect balanced dynamic mics or line level devices even if this switch is on, but connecting unbal- anced devices or devices whose transformers are center- grounded will cause hum or malfunctions. Shorting the +48VDC can also damage your mixer. Also, turn down the Stereo Master faders (25A, 25B) to prevent possible sharp transient noise from damaging the speakers when turning the phantom power on or off.]

(36) (38)







(37)	(39)		(40)

		BACK PANEL