MaxTech NXP-16 manual FCC Class B Statement, Disclaimer, Copyright, And Other Notices

Page 14

the unit by any unauthorized service center. This warranty is voided if the product has been abused, misused, modified, or repaired by an unauthorized service center.

8.2 FCC Class B Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal- lation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However,thereisnoguaranteethatinterfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep- tion, which can be determined by turning the equipment off andon,theuserisencouragedtotrytocorrecttheinterference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and the receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

Consult the dealer or an experienced radio / TV technician for help

Notice: 1) Shielded cables, if any, must be used in order to comply with the emission limits. 2) Any change or modifica- tion not expressly approved by the Grantee of the equipment authorization could void the user’s authority to operate the equipment.

8.3 Disclaimer, Copyright, And Other Notices

The information contained in this manual has been validated at the time of this manual's production. The manufacturer reserves the right to make any changes and improvements in the product described in this manual at any time and without notice. Consequently the manufacturer assumes no liability for damages incurred directly or indirectly from errors, omissions or discrepancies between the product and the manual.

All registered trademarks are the property of their respective owners.

Copyright © 1997 All rights reserved. No reproduction of this

13

Image 14
Contents NXP-16 Contents Unpacking Your Network Adapter Section Two InstallationHardware Installation Card Configuration Windows 95 Release 4.00.950 B Configuration in WindowsWindows 95 Release Configuration in PnP Systems without Windows Configuration in Legacy SystemsTesting The Adapter RAM Test Checks on-board RAM Align ROM and socket notches Section Three Driver InstallationSection Four Troubleshooting Cable Problems I/O Base Address and IRQ ConflictSection Six Specifications Section Five Cable InformationSection Seven Technical Support You may also reach us through Hour BBS 562Five Year Limited Warranty Section Eight NoticesFCC Class B Statement Disclaimer, Copyright, And Other NoticesGZ/DR Version