MaxTech NXP-16 manual Section Three Driver Installation, Section Four Troubleshooting

Page 9

ning the SETUP program.

Figure 2

Align ROM and socket notches

3.Follow the Remote Boot Workstation instal- lation procedure given in your network oper- ating system manual (i.e. create a Boot Image on the server for Novell networks, or start remote booting services on LAN Man- ager networks, etc.).

Section Three - Driver Installation

The network operating system (i.e. Novell, Win- dows NT, LAN Manager, etc.) that you are using requires a driver to access the network adapter card. The network adapters are NE-2000 com- patible and can use the NE-2000 driver supplied with your network operating system. Drivers for most popular network operating systems are in- cluded on the driver diskette in separate subdirectories. These drivers can be copied to your hard-drive by using the INSTALL.EXE program on the driver disk. Information on using each driver is available by running HELP.EXE from the root directory of the driver disk.

Section Four - Troubleshooting

This section describes some of the common prob- lems you may encounter while using your network adapter. When troubleshooting, you should make sure that the network you are connected to is

8

Page 8 Page 10
Image 9
Page 8 Page 10
Contents NXP-16 Contents Section Two Installation Hardware InstallationUnpacking Your Network Adapter Card Configuration Configuration in Windows Windows 95 ReleaseWindows 95 Release 4.00.950 B Configuration in Legacy Systems Configuration in PnP Systems without WindowsTesting The Adapter RAM Test Checks on-board RAM Section Three Driver Installation Section Four TroubleshootingAlign ROM and socket notches I/O Base Address and IRQ Conflict Cable ProblemsSection Five Cable Information Section Six SpecificationsYou may also reach us through Hour BBS 562 Section Seven Technical SupportSection Eight Notices Five Year Limited WarrantyDisclaimer, Copyright, And Other Notices FCC Class B StatementGZ/DR Version
Top Page Image Contents