MaxTech xpvs336i user manual @ wait for five seconds of silence flash

@wait for five seconds of silence

!flash

;return to Command Mode after dialing

DS=n		Dial one of the four telephone numbers
		(n=0-3) stored in the modem’s non-volatile
		memory.
E_	E0	Commands are not echoed
	E1	Commands are echoed

+++Escape Characters - Switch from Data Mode to Command Mode

H_	H0	Force modem on-hook (hang up)
	H1	Force modem off-hook (make busy)
I_	I0	Display product-identification code
	I1	Factory ROM checksum test
	I2	Internal memory test
	I3	Firmware ID
	I4	Reserved ID
L_	L0	Low speaker volume
	L1	Low speaker volume
	L2	Medium speaker volume
	L3	High speaker volume
M_	M0	Internal speaker off
	M1	Internal speaker on until carrier
		detected
	M2	Internal speaker always on
	M3	Internal speaker on until carrier detected
		and off while dialing
N_	N0	Disable Autoscan mode
	N1	Enable Autoscan mode
O_	O0	Return to Data Mode
	O1	Return to Data Mode and initiate an
		equalizer retrain

PSet Pulse dial as default

Q_	Q0	Modem sends responses
	Q1	Modem does not send responses
Sr?		Read and display value in register r.
Sr=n		Set register r to value n (n = 0-255).
T		Set Tone Dial as default
V_	V0	Numeric responses
	V1	Word responses
W_	W0	Report DTE speed only

8