MaxTech xpvs336i Section One - Introduction, Section Two - Installation, Unpacking Your Modem

Page 3
Section One - Introduction

Section One - Introduction

This 33.6 Kbps Plug and Play FAX/Voice/Data Speakerphone Modem connects your computer to all popular high speed modems available today. Your new modem features advanced speakerphone functions for hands-free voice communication and is compatible with Plug and Play (PnP) systems for simplified installation and configuration. This manual describes the hardware installation procedures for your new modem product. Additional information on AT commands and S-registers is provided so that your system can be customized for a particular operating environment.

Section Two - Installation

This section will provide step by step instructions on how to install your new 33.6 Kbps FAX/Voice/Data modem. Installation of this modem product is a three- step process consists of 1) actual hardware installation,

2)plug and play configuration, and 3) communication software installation and configuration.

2.1Unpacking Your Modem

Be certain that you have all the items listed below. This package contains:

• A modem

• A telephone cable

• User's manual

• Software for the modem

•Software user's manual

2.2What You Need You will need:

1.A phillips-head screw driver

2.A) A Plug and Play enabled Operating System (e.g., Windows 95),

or

B) A Plug and Play Revision 1.0a compliant PC.

Proceed to Section 2.3 now if you have every- thing required.

If you have neither 2A or 2B above, you have two options to provide Plug and Play functionality to your PC.

1. Install Windows 95

1

Page 2 Page 4
Image 3
Page 2 Page 4
Contents MAN081 Rev High Performance V.34+/V.42bis 33,600 BPS Internal Plug and PlayFAX/Voice/Data Modem Featuring Advanced Full Duplex Speakerphone FunctionsContents 2.2 What You Need You will need Section Two - InstallationSection One - Introduction 2.1 Unpacking Your Modem2.3 Hardware Installation Expansion SlotsBack Plate Section 2.4.3 if you are running Windows 3.1x on a non-PnP PC 2.4.3 Configuring in a Non-Plug and Play System 2.4.2 Configuring in a Plug and Play System without Windows2.5 Software Installation and Configuration 2.7 Testing Your Modem After Installation 2.8 Using Your Modem2.9 Where To Go From Here Section Three - AT Command Set @ wait for five seconds of silence flash Modem returns to Command Mode after Reportlinespeed,errorcorrectionprotocolModemsendsbreaksignalforfourseconds Force Carrier Detect Signal High ONGrant Remote Digital Loopback Test Configuration Profile 0 active uponReturns Caller ID capabilities of modem enabledwithV.8/V.32AnnexA.ParameterEnable MNP Class 5 and V.42bis data 300, 33600. Parameter “a” specifies theV.42 data link only MNP data link onlyV.42/MNP/Normal data link Section Four - S Registers Enable Caller ID detection and reportingFunction Range/units DefaultTable 4-1 S - Registers RegisterSection Six - Troubleshooting Modem does not respond to commandsSection Five - Result Codes Modem makes a connection but no data appears on your screen Modem experiences errors while communicating with a remote modemModem does not dial Modem dials but does not connectSection Seven - Support and Service Appendix A - SpecificationsModem exhibits poor voice record or playback Appendix B - FCC , DOC & Other Notices FCC ComplianceFCC Class B Statement DOC Compliance Information UL Notice
Top Page Image Contents