LSI 20860 manual Device driver does not see one of the Scsi devices

Page 21

The device driver does not see one of the SCSI devices.

1.Reboot the computer.

2.Make sure the SCSI devices have different ID numbers (the boot drive should have the lowest ID).

3.Make sure both ends, but only the ends, of the SCSI bus are terminated.

4.Check the cable and power connections.

Troubleshooting

1-13

Image 21

Contents N u a r y 2 0 0 USER’S GuideElectromagnetic Compatibility Notices Iii Page Preface AudienceOrganization Revision Record Related PublicationsContents ViiiContents Chapter Using LSI20860 FeaturesPCI Interface Board Requirements Scsi InterfacePhysical Environment Physical CharacteristicsMaximum Power Requirements Electrical CharacteristicsThermal, Atmospheric Characteristics Electromagnetic ComplianceSafety Characteristics Installing the LSI20860Using the LSI20860 Connecting Scsi Devices Internal Scsi Bus Connections Internal Scsi Devices Chained Together External Scsi Bus ConnectionsMultiple External Devices Chained Together Scsi Bus TerminationScsi Bus Termination During installation, no Scsi devices are found Setting Scsi IDsDevice driver does not see one of the Scsi devices Using the LSI20860 Appendix a Glossary of Terms Abbreviations Internal Scsi Host AdapterLocal Bus MainboardPort Number Scsi BusScsi Device Single-Ended TerminationUltra Scsi Customer Feedback Excellent Good Average Fair Poor Reader’s CommentsCalifornia Distributors by StateNew York Direct Sales Representatives by State Components and Boards North America Sales Ofﬁces and Design Resource CentersKorea International Distributors China Beijing LSI Logic International Services Inc