Leviton Internet Gateway specifications Specifications, Installing the Gateway

4.In the Configuration window, select the TCP/IP protocol line that has been associated with your network card or adapter. (Figure 33)

33

5.Click Properties button, then choose IP Address tab. Select Obtain an IP address automatically. Press OK. You have completed the client settings. (Figure 34)

NOTE: Windows may ask you for original Windows installation files, supply them as needed.

				34
4: SPECIFICATIONS
Technical Specifications
Standards	IEEE 802.3, IEEE 802.3u
Protocol:	CSMA/CD, PPPoE, PPP, PPTP Client, ARP, DHCP Client and Server, TCP/IP, UDP, ICMP,
	RIP1/RIP2, DNS Proxy, Dynamic DNS, SNTP
Ports:	Four	10/100 Mbps LAN ports (1 shared Uplink port)
	One	10/100 Mbps WAN port
Connector:	RJ-45 connector
Speed	WAN Router		10/100 Mbps (Half Duplex), 20/200 Mbps (Full Duplex)
	LAN Switch		10/100 Mbps (Half Duplex), 20/200 Mbps (Full Duplex)

Cabling Type

(Star Topology): 10BaseT: UTP/STP Category 3 or 5

100BaseTX:	UTP/STP Category 5
LEDs:	Power, Diag per unit. Link/ACT, FDX /COL, 10/100 per port
NAT:	Translate private IP to public IP
Multiple DMZ:	Support multiple public IP translate to multiple private IP
Virtual Server:	Provide public services on the network
Firewall:	IPSec, PPTP, L2TP pass through, Hacker Attack Prevention
Management:	Web-based Configuration

LED Color Function

Diag (green): Lights to indicate the Gateway is in self-diagnosis mode during boot-up. The LED turns off to indicate successful completion of self-diagnosis.

Power (yellow): Lights to indicate the Gateway has power.

Link/Act (green):

1.Lights to indicate a functioning network link from the Gateway through the corresponding port (1 through 4 and WAN) to an attached device.

2.Blinks to indicate the Gateway is actively sending or receiving data over that port.

FDX/COL (green):

1.Lights to indicate a connection made through the corresponding port is running in Full Duplex mode.

2.Blinks periodically to indicate the connection is experiencing collisions.

100/10 (yellow):

1.Lights for any port to indicate that the port is operating at 100Mbps.

2.Off to indicate that the port is operating at 10Mbps while the network is still operating.

Rear Panel(Figure 2)

The rear panel of the Gateway has a power connector and one reset button.

DC INPUT

RESET

2

Reset Button

CAUTION: Pressing the reset button will restore the Gateway to its factory default settings. Note that this should be done only when all troubleshooting options have been attempted, including calling Leviton's Technical Support at 1-800-824-3005.

Pressing the reset button during operation may create an IP address conflict between your computer and the Gateway. If this occurs, a system reboot may be required.

INSTALLING THE GATEWAY

Preparing for Installation

Before connecting the Gateway to any network device, obtain the following information from your ISP. This information is required to successfully configure your Gateway.

·PPPoE User Name and Password or

·Fixed Internet IP Address assigned by your local ISP

·Your Subnet Mask

·Your Default Gateway

·Your Primary DNS IP address

Installing and Cabling your Gateway (Figure 3)

1.Power all devices down. This should include your computers, Cable or DSL modem and the Gateway.

2.Connect one end of a standard network cable to the 10/100 RJ-45 LAN port on the Gateway, then connect the other end of the cable to the computer.

3.Connect the Gateway to your Cable or DSL modem.

18 3