1.0INTRODUCTION
7KHý/LHEHUWý836WDWLRQý6êýXQLQWHUUXSWLEOHýSRZHUýVXSSO\ýõ836ôýV\VWHPýSURWHFWVý\RXUýYDOXDEOHý
HTXLSPHQWñýGDWDñýDQGýSURFHVVHVýIURPýWKHýFRQVHTXHQFHVýRIýGLVWXUEDQFHVýLQýWKHýXWLOLW\ýSRZHUýVRXUFHïý
7KLVý836WDWLRQý6êý2SWLRQVý8VHUªVý0DQXDOýGHVFULEHVýWKHýRSWLRQVýDYDLODEOHýIRUýWKHý836ýDQGýJLYHVý
GHWDLOHGýLQVWDOODWLRQýDQGýRSHUDWLQJýLQVWUXFWLRQVýIRUýHDFKïý
7RýHQKDQFHýWKHýIOH[LELOLW\ýDQGýSHUIRUPDQFHýRIý\RXUý836WDWLRQý6êý836ñý/LHEHUWýRIIHUVýVHYHUDOýIHDð
WXUHVýDQGýRSWLRQVýWKDWýFDQýEHýRUGHUHGýDVýVWDQGDUGýHTXLSPHQWýRUýSXUFKDVHGýVHSDUDWHO\ýDQGýILHOGð
LQVWDOOHGýE\ý\RXýRUýE\ýDýTXDOLILHGý/LHEHUWý&XVWRPHUý6HUYLFHýDQGý6XSSRUWýWHFKQLFLDQýRUý/LHEHUWýGLVð
WULEXWRUïý2SWLRQVýLQFOXGHã
‡3RZHUý6XSSO\ó
‡5HPRWHý6WDWXVý3DQHO
‡3URJUDPPDEOHý5HOD\ý%RDUG
‡,QSXWý&RQWDFWý,VRODWRUýõ,&,ôó
‡'&ý*URXQGý)DXOWý'HWHFWRUó
‡6103ýõ(WKHUQHWýRUý7RNHQý5LQJô
‡0RGHP
7KHý836WDWLRQý6êýFDELQHWýKDVýDýGHGLFDWHGýDUHDýZKHUHýRSWLRQýKDUGZDUHýPXVWýEHýLQVWDOOHGïý$ý PRXQWLQJýEUDFNHWýSURYLGHVýILYHýVORWVýGHVLJQHGýWRýDFFRPPRGDWHýWKHýRSWLRQVýIRUýSURSHUýDQGýFRQYHð QLHQWýLQVWDOODWLRQïý7KHý5HPRWHý6WDWXVý3DQHOýRSWLRQýGRHVýQRWýXVHýWKHýPRXQWLQJýEUDFNHWýIRUýLWVý LQVWDOODWLRQï
7DEOH ìýDQGýWKHýQRWHVýEHORZýWKHýWDEOHýVXPPDUL]HýWKHýVSHFLDOýUHTXLUHPHQWVýRIýHDFKýRSWLRQï
Table 1 | Option Requirements |
|
|
| |
|
|
|
|
|
|
|
|
|
| Input Contact |
|
| Option | Mounting Slots | Logic | Isolator | Power Supply |
| Required | Connection | Option | Option Required | |
Power Supply* | Yes (if installed | — | — | — | |
|
| separately) |
|
|
|
|
|
|
|
| |
Remote Status Panel | No | — | — | Yes | |
|
|
|
|
| |
Programmable Relay | Yes (one for each | 1 connection | — | — | |
(2 boards max.) | board installed) |
|
|
| |
|
|
|
|
| |
Input Contact Isolator | Yes | 1 connection | — | Included on board | |
(w/ Power Supply)* |
|
|
|
| |
|
|
|
|
| |
DC Ground Fault Alarm* | Yes | — | 1 channel | — | |
|
|
|
|
| |
SNMP (Ethernet or | Yes | 1 connection | — | — | |
Token Ring) |
|
|
|
| |
|
|
|
|
| |
Internal Modem | Yes | 1 connection | — | — | |
|
|
|
|
|
|
*These options require complete shutdown of the UPS system if installing or already installed. (See 1.1 - Opening the UPStation S3.) All other options can be installed while the UPS is on bypass.
Notes:
1.You must install a mounting rack if an option you intend to install requires a mounting slot. The mounting rack has five mounting slots.
2.If a DC Ground Fault Detector is installed, an Input Contact Isolator is also required. The Input Contact Isolator has eight input channels and a power supply.
3.The SNMP (Ethernet or Token Ring) and Internal Modem options each use one logic connection. Two logic connections are available, therefore, some option combinations are not possible.
4.Only one logic connection is required for any combination of one or two Programmable Relay boards and/or an Input Contact Isolator.
5.Up to three Remote Status Panels can be connected to an UPStation S3. One Power Supply and a Programmable Relay option are required.
6.Options requiring a Power Supply option can use the power supply mounted on the Input Contact Isolator option if one is installed.
2 Introduction