Lucent Technologies 7820-0766-004 manual Set all configuration to factory setting

Page 21

Command-Line Interface

Bridging commands

Table 3-1. Main menu and second-level bridging commands (continued)

Main menu	Second-level menus/description

sdsl	auto	- <Enable><Fast><Scan><Disable>
	cell	- <Enable><Disable> idle-cell header
	dbit	- configure the SDSL data bit as normal or reverse
		polarity
	default	- set SDSL configuration back to factory setting
	enable	- activate the last updated SDSL parameters
	maxrate	- configure the SDSL autobuad max rate
	rate	- manually configure the SDSL line rate
	scramble	- <Enable><Disable> payload scrambling
	smbit	- configure sign/magnitude bit sequence
	status	- display the configuration and status of current
		SDSL setting
	terminal	- configure modem to COE or CPE mode

default	set all configuration to factory setting

lan	fullduplex - fullduplex <Disable><Enable>
	setip	- setup the IP address, and subnet mask for Ethernet
		connection
	show	- show LAN configuration

list	list status for enabled PVC

manage	setpass	- change password

mode	please select bridge or router:(b/r,b)

ping	ping IP

quick (for adsl)	R1483(r)/ IPoA(i)/ PPPoA(p)

quick (for sdsl)	configure VPI/VCI

CellPipe™ 20 Series User’s Guide

3-5

Image 21

Contents CellPipe 20 Series Lucent Technologies Customer Service Customer ServiceFinding information and software Obtaining technical assistanceCustomer Service Contents Upgrading System Software About this guide IntroductionWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?Lucent TURN-UP CellPipe 20 Series managementLucent TURN-UP Page Verifying package contents SetupItems you need for installation Connecting CellPipe 20 Series productsItems you need for installation CellPipe 20 Series rear panels Connecting CellPipe 20 Series productsConsole setup Checking status lightsChecking status lights Console setup Page Syntax of command-line interface Command-Line Interface Displaying information about a command Using the commands Using the commands Viewing the main menuDisplaying second-level commands Bridging commandsSaving configurations Bridging commandsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Auto-provisioning Configuring a 20 Series CellPipeConfiguring WAN interface Sdsl commands and configurationsConfiguring WAN interface Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface Configuring LAN interface in bridging modeConfiguring LAN interface Configuring LAN interface in routing mode Configuring the manage command Configuring the mode commandConfiguring the manage command Quick command in bridging mode Configuring the quick commandQuick command in routing mode Configuring the quick commandConfiguring the r1483 command R1483 command in bridging modeConfiguring the r1483 command R1483 command in routing mode Configuring the dnsrelay command Configuring the ipoa commandConfiguring the dnsrelay command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Preparing to upgrade Upgrading System SoftwareObtaining software Upgrading software Upgrading softwareWarranties and FCC Regulations Product warrantyOut-of warranty repair Warranty repairFCC Part 15 Notice FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice