LaCie Brick Step, Connect the power supply and switch on the drive, Getting Connected, page

LaCie Brick Hi-Speed USB 2.0	Getting Connected
	page 10
Desktop Hard Drive User’s Manual

Step 2.1 –

Connect the power supply and switch on the drive.

	1	2	3
4	Cable A	Power Supply Brick	Cable B

There are two cables that are supplied with the power supply: one cable (A) connects to a power outlet, such as a wall outlet or a surge protector; and the other cable (B) connects to the LaCie drive.

1Connect Cable A to your LaCie Drive.

2Connect Cable B to the Power Supply brick.

3Connect Cable B to a grounded surge protector or wall outlet.

4Turn the drive on and off by using the On/Off switch.

Warning! Use only the AC adapter supplied with your specific LaCie drive. Do not use a power supply from another LaCie drive or another manufacturer. Using any other power cable or power supply may cause damage to the device and void your warranty. Always remove the AC adapter before transporting your LaCie drive. Failure to remove the adapter may result in damage to your drive and will void your warranty.

Important Note: You may use your LaCie drive when in a foreign country, thanks to its autoswitching 100-240 Volt power supply. To be able to use this feature, you may need to purchase an appropriate adapter or cord. Consult LaCie Technical Support for assistance in choosing the right adapter. LaCie accepts no responsibility for any damage to the drive resulting from the use of an inappropriate adapter. Using an adapter other than one authorized by LaCie will void your warranty.