LevelOne GSW-2490TXM manual Connecting to the Switch

Figure 3-3. Mount the 24TP+1Fiber Module Switch in an EIA standard 19-inch Rack

Note: For proper ventilation, allow about at least 4 inches ( 10 cm ) of clearance on the front and 3.4 inches ( 8 cm ) on the back of the Switch. This is especially important for enclosed rack installation.

Connecting to the Switch

The Console port is a male DB-9 connector that enables a connection to a PC or terminal for monitoring and configuring the LevelOne GSW-2490TXM SNMP Switch. Use the supplied RS-232 cable with a female DB-9 connector to connect a terminal or PC to the Console port.

The Console configuration ( out of band ) allow you to set your Switch to enable a user at a remote console terminal to communicate with the LevelOne GSW-2490TXM SNMP Switch as if the console terminal were directly connected to it.

11