LevelOne GSW-2490TXM manual Connecting to the Network, Pre-Installation Requirements

Page 8

LEDs will soon flash red.

When the Switch passes the self-test within 15 seconds, the Link /ACT LED turns on.

Note : If the Switch fails the self-test, the Diag LED will blink.

3.

Connecting to the Network

This section provides the installation procedure and instructions for assigning IP address.

Pre-Installation Requirements

Before you start hardware installation, make sure your installation environment has below items:

PCs with 10/100Mbps Ethernet NICs/ 100Mbps Fiber NICs: Your PC must have a standard Ethernet interface to connect to the Switch.

UTP cable with RJ45 connectors/ Fiber cable with MT-RJ/ VF-45 connectors: Check if the cable and connectors work properly.

A power outlet: 100 to 240V AC at 50 to 60 Hz: Make sure that the Switch power is accessible and cables can be connected easily.

8

Image 8

Contents LevelOne Features Gbic SCPackage Contents Snmp Network Management Management MethodsConsole and Telnet Management 10/100Base-TX RJ-45 ports Auto MDI/MDIX Hardware DescriptionFront Panel Console Port LED IndicatorsExpansion Slots Rear Panel Power OnDiagnostic Test Connecting to the Network Pre-Installation RequirementsMounting the Switch Desktop MountingRack-mounted Installation Attach mounting brackets with screwsConnecting to the Switch Login in the Console Interface Settings of communication parametersMain Menu System InformationManagement Setup Network ConfigurationSerial Port Configuration Snmp Community SetupManagement Capability Setup Trap ReceiverTrap Filter Setup 13. The Management Capability setup MenuSwitch Device Configuration Device Control MenuSwitch Port Configuration Permanent Address ConfigurationPort Statistics Static Unicast Address ConfigurationStatic Multicast Address Configuration Spanning Tree Protocol Configuration 19. The Port Statistics menuSpanning Tree Protocol Port Configuration Post-Based Vlan Configuration1Q Vlan Configuration 1 .1Q Vlan Configuration23. The Port Based Vlan Configuration menu Dynamic Vlan TableVlan Untagged Configuration Garp Configuration26. The Garp Configuration menu MTU/MDU Per-Port Vlan TableTrunk Group Configuration Igmp Snooping TablePort Mirroring Configuration 29. The Trunk Configuration MenuUser Authentication 31. The User Authentication MenuSystem Utility System Restart Factory ResetLogin Timeout Interval Web-Based Management System DownloadSystem Login About Web-based ManagementManagement Setup System InformationSerial Port Configuration Menu Snmp Community Setup Menu Management Capability Setup Menu Switch Configuration Device ControlSwitch Port Configuration 12. The Trunk Group in Switch Port Configuration Menu Page 16. The Spanning Tree Protocol Configuration upper Menu 17. The Spanning Tree Protocol Configuration lower Menu Vlan Configuration 19. The Spanning Tree Protocol Port Configuration lower Menu21. The Static Vlan Configuration Menu 23. The Untagged Configuration Menu Igmp Configuration User Authentication 27. The Igmp Configuration MenuSystem Utility 29. The System Restart MenuUpdate Setting 31. The Login Timeout Interval MenuNetwork Configuration Collapsed Backbone Application Departmental Bridge Collapsed Backbone ApplicationHigh Performance Switched Workgroup Departmental Bridge ApplicationIeee 802.1Q Vlan Application Port-based Vlan WorkgroupShared Server Product Specifications MAC Address