2.2. Unpacking
1.Inspect the packaging for crushes, cuts, water damage or any other evidence of mishandling during transit. If any damage appears pres- ent, photograph the packaging before opening, for reference.
2.Unpack the system. See Figure 1.
3. INSTALLATION
3.1. Mounting the System into a Rack
NOTE: The rail kit is suitable for 19” racks with square and round holes only. The minimum distance between vertical rack posts is 24” (610mm); the maximum distance is 36” (914mm). The rail location pins are pre- assembled to suit square hole or round hole racks. The pins should not be removed.
1.Remove the Rack Mounting Rail Kit from the Accessory Box and check for damage.
2.Ensure the
3.Locate the rail location pins inside the front of the rack and extend the rails to enable the rear location pins to engage. Ensure the pins are fully located in the holes in the rack posts (see Figure 2).
4.Install the front and rar clamping screws (see Figure 2). The screws should be left loose enough to allow the rail to move sideways on its slots.
5.Slide the enclosure fully home on its rails.
6.Withdraw the enclosure approximately 200mm and fully tighten the front and rear clamping screws (see Figure 2).
7.Fasten the front of the enclosure using the two captive screws a shown in Figure 2.
Figure 1 - Unpacking the Enclosure
Figure 2 - Rack Installation
LaCie Quick Install Guide | 4 |