| support FAT and NTFS file format |
USB Eject Button | Press and release to prepare the USB device for removal. When the USB LED |
| starts blinking slowly, it is safe to remove the USB device. |
|
|
LAN | Use this to connect the NAS to your 10BaseT or 100BaseT hub. |
connector | |
|
|
Power Switch | This is a |
| If power is Off, press once to turn On. |
| If power is On, press once to start the Shutdown sequence. During Shutdown, the |
| Ready LED will blink. When Shutdown is completed, all LEDs will turn off. |
Audible Warnings
Audible warnings are given by the following signals.
1 Beep | Reset button or power switch is pressed or system is ready to use |
|
|
2 Beeps | NAS is a DHCP client, but no DHCP Server responded to the DHCP |
Repeated every 5 seconds | client request. This means that the NAS could not obtain a valid IP |
for 1 minute. | address. |
|
|
3 Beeps | Hard disk usage exceeds 98% |
Repeated every 5 seconds |
|
for 3 minute. |
|
|
|
Page 4