Black Ground Wire, CAR Antenna Input | Audiovox ACC56, ACC-56

WIRING THE FM MODULATOR (con't.)

BLACK GROUND WIRE

The 3 foot Ground wire (black) attached to the FM modulator must be secured to a grounded metal part of the car’s chassis. If you cannot find an existing bolt or screw to fasten it to, you must drill a hole in the metal and secure it with a screw. To insure a good ground, remove any paint or grease where the wire will connect.

CAR ANTENNA INPUT

Locate your existing car radio antenna cable. This is normally a black cable about as thick as a pencil and will be plugged into a socket on the rear of your car radio. Unplug this antenna lead and plug it into the mating female socket on the FM modulator.

IMPORTANT - Some Import cars have a special dual antenna called “DIVERSITY ANTENNA”. If your car has this type of antenna system, you will find the antenna cable will not fit the socket on the FM modu- lator. Use of the ACC-56 with “DIVERSITY ANTENNA" is not recommended. You may also find some late model GM cars have an antenna plug that is too small to mate with the FM modulator. If this is found, call Audiovox’s Toll-Free Assistance for a special adapter (1-800-645-4994). This adapter can also be purchased at any car stereo installation center.

RADIO ANTENNA OUTPUT

Attached to the FM modulator is a male antenna plug. Simply plug this into the socket on the car radio from which you just removed the car antenna cable.

REMOTE CONTROL CABLE

Attached to your remote control is a cable that plugs into the remaining 5-pin socket on the end of the FM modulator. Position the remote control near the area you will permanently mount it and route the cable to the FM modulator. Plug the cable into the FM modulator.

EXISTING

SCREW

GROUNDED METAL PARTOR BOLT OF CHASSIS

BLACK GROUND WIRE

FM MODULATOR

EXISTING CAR RADIO (UNPLUG ANTENNA CABLE)

EXISTING CAR ANTENNA

FM MODULATOR

FEMALE CONNECTOR

CAR ANTENNA CABLE

CAR RADIO

FM MODULATOR

MALE ANTENNA PLUG

FM MODULATOR

REMOTE CONTROL

REMOTE CONTROL CABLE