Audiovox ACC-56, ACC56 owner manual Before Installing the Unit, Additional 10-DISC Magazines

Page 4

BEFORE INSTALLING THE UNIT

REAR

 

 

 

Transport Lock Screws

 

 

The mechanism in the CD changer is "locked" into place during shipment by three

 

 

transport lock screws. Be sure to remove the screws prior to installation.

BOTTOM

FRONT

 

 

l Caution l

After removing the transport lock screws, place the supplied seals (A) over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction.

Installation and Wiring Precautions

TRANSPORT LOCK SCREWS (2 RIGHT SIDE, 1 LEFT SIDE)

1 To prevent a short-circuit,

lBe sure to turn off the ignition and remove the negative (-) battery cable, prior to installation.

lConnect power wires last.

NOTE: If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation not to cause a short circuit.

2 Do not install the unit in the following locations.

lLocations exposed to direct sunlight.

lWhere hot air is discharged from the car heater.

lIn areas subject to extreme temperatures.

3

Incorrect installation can cause the disc to "skip" when playing. Be sure Mount the unit firmly in place, using the supplied

 

brackets and screws.

4 l Be sure to use the supplied screws.

lBe careful not to snag any wires when tightening screws.

lDo not use any of the screws that are part of the brake or steering system, to install the unit.

lBe careful not to damage the car wiring.

5 l This unit cannot be installed on its side, end, or upside down. Installation in such positions will cause malfunctioning of the mechanism.

ADDITIONAL 10-DISC MAGAZINES

Additional CD Magazines are available as an accessory item (Part No. ACC-56MAZ). Visit the store where your ACC-56 was purchased or, contact Audiovox directly for pricing and shipping information (1-800-645-4994). All checks or money orders are to be made payable to Audiovox Electronics Corp. NOTE: Never send Cash when ordering.

Audiovox Electronics Corp.

150 Marcus Blvd.

Hauppauge, N.Y. 11788

Attn: Parts Department

NOTE: New York residents, please include applicable sales tax.

4

Image 4
Contents Model ACC-56 REMOTE-CONTROL RF Modulated Disc CD Changer Introduction Other Accessories Installation PartsMain Unit Before Installing the Unit Additional 10-DISC MagazinesWhere to Install the Changer Trunk Mounting SedansHATCHBACKS, Wagons & Vans Under PASSENGER’S Front SEAT/BEHIND SeatInstallation Procedure for Horizontal InstallationProcedure for Vertical Installation Procedure for 45 Angle Installation Overall Wiring View Wiring the CD Changer Orange with White Stripe WireGreen with White Stripe Power WireBlack Ground Wire Remote Control CableCAR Antenna Input Radio Antenna OutputAdjustment of FM Modulator Tuning Mounting the FM ModulatorControls Preparing for OperationUSE of Controls Bl Disc +/- Select ButtonHints for Correct and Safe Operation Handling the DiscsInterruptions in Sound Skipping 8cm CD-SINGLESUSE of the CD Magazine Playing Surface UpCD Changer Operating Instructions Specifications ChangerTroubleshooting Symptom Possible Cause RemedyMonth Limited Warranty Audiovox Electronics Corp., Hauppauge, NY