Lava Computer IP/232 manual Hardware Setup

Page 3

2Hardware Setup

1.Connect the power supply to the LAVA PayLink-IP/232 and to AC power. The power (red) LED will light to indicate that the unit is receiving power.

2.Connect an Ethernet cross-over cable to the Ethernet RJ-45 jack of the LAVA PayLink-IP/232. Attach the other end of the crossover network cable to a host PC directly.

Network status is indicated by two LEDs on the RJ-45 connector. The left (yellow) LED indicates network activity. It is on by default, turning off when network activity occurs at the PayLink-IP. The right (green) LED indicates a network link. It is off by default, but lights when a network link exists.

Network

Activity and Link

indicators

Network connector (RJ-45)

Power

Power

indicator

connector

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Lava PayLink-IP/232 Quick Installation Guide Getting Started Hardware Setup Single Port PayLink-IP/232 Configuring network settings ConfigurationOpening screen Configuration MenuNetwork Settings IP address Default gatewayDhcp enabled Device nameAssigned local TCP port Submit changes and reboot deviceRestore factory defaults and reboot device Reboot devicePort configuration Serial Port SettingsBaud rate Flow control Data bitsParity Stop bitsHost Settings Host configurationTerminal Side Data and Format Configuration Terminal Side Data and Protocol ConfigurationProtocol Configuration Password selection Password SelectionUpgrading Software Lava
Top Page Image Contents