Lava Computer manual Single Port PayLink-IP/232

Page 4

3

3.Open a web browser to the IP address of the PayLink-IP and configure the device as described in the "Configuration" section of this manual.

4.After configuring the LAVA PayLink-IP/232, attach it to your network and connect a payment terminal to its serial port.

Serial port activity is indicated by two status LEDs per port. The yellow LED lights when the serial port is transmitting data. The green LED lights when the serial port is receiving data.

Serial Tx indicator

Serial Rx	Serial connector
indicator

Single Port PayLink-IP/232

Image 4

Contents Lava PayLink-IP/232 Quick Installation Guide Getting Started Hardware Setup Single Port PayLink-IP/232 Configuration Configuring network settingsConfiguration Menu Opening screenNetwork Settings Default gateway Dhcp enabledDevice name IP addressSubmit changes and reboot device Restore factory defaults and reboot deviceReboot device Assigned local TCP portSerial Port Settings Port configurationBaud rate Data bits ParityStop bits Flow controlHost configuration Host SettingsTerminal Side Data and Protocol Configuration Terminal Side Data and Format ConfigurationProtocol Configuration Password Selection Password selectionUpgrading Software Lava