Chapter 3 LED Indicators
Figure 3-1 shows the LED indicators, which indicate the link status of each of the ports, whether the LSW switch is receiving power, and the presence of network activity and collisions on the network.
Figure 3-1 LSW2F16 Front Panel LED Indicators
|
|
| 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | PORT NO. | Full- | |
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
| FULL/COL | ||
LSW2F16 | 10/100 |
|
|
|
|
|
|
|
| LINK/ACT | Duplex/Collision | ||
|
|
|
|
|
|
|
|
|
| 10/100 Mbps | Link/Activity | ||
|
|
|
|
|
|
|
|
|
|
| FULL/COL | ||
|
|
|
|
|
|
|
|
|
|
|
| ||
10/100Mbps |
|
|
|
|
|
|
|
|
|
| LINK/ACT | Full- | |
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | PORT NO. | |||
|
| ||||||||||||
3.1 Power LED
The LED on the front panel labeled PWR is used to indicate that the switch is receiving power and is turned on. If the LED is off, check the following to isolate the problem:
▼Make sure the power cord is properly connected to the power outlet and is properly inserted into the power connection on the switch
▼Determine whether or not the outlet is functional by plugging another device into the receptacle
▼Turn the power switch to the ON position. If there are no problems and the LED still does not light, contact your dealer
3.2 10/100 Mbps LEDs
Each 10/100 port (Ports 1 and 2) have the 10/100Mbps LED on the front panel. When the LED is ON, it indicates the port is in 100Mbps mode. Otherwise, its working in 10Mbps mode.
12