Lantronix LSW2F8 manual Mounting Bracket Installation

Page 11

2.4 Mounting

Your LSW2F8 or LSW2F16 switch is delivered with two brackets for mounting the switch in an EIA standard 19-inch rack. Secure the mounting brackets onto the sides of the LSW switch, fastening them with screws as shown in Figure 2-6.

Figure 2-6 Mounting Bracket Installation

LSW2F8

FULL/COL LINK/ACT

9	10
8
7
6
5
4
3

2 1

If your site uses only a few switches and is not equipped with a mounting rack, you may choose to place the LSW switch on a table or wiring closet shelf. In this case, use the four self-adhesive rubber feet, which are provided with the switch for cushioning purposes. Stick them at the four corners of the bottom surface of the LSW switch to cushion it against vibration.

Image 11

Contents LSW2F8, LSW2F16 Table of Contents Product Introduction Features Product Specifications Planning Your Network Packing ChecklistFileserver Link Application Fileserver LinkLSW2F16 Backbone Link3 10/100Mbps Bridging InstallationLSW2F8 Switch Front Panel Mounting Mounting Bracket InstallationLSW2F16 Connecting the LSW Switch10/100 Mbps LEDs Power LEDLink/Activity LEDs Full/Col Full or Half Duplex/Collision LEDsLimited Warranty Page Declaration of Conformity Part no -140 Rev.A