LevelOne FSW-1611TX manual Troubleshooting

E. Troubleshooting

I.Link LED does not lit after cable is connected to the port.

ØVerify that the other end of the cable is connected to a device that is powered on and on-line.

ØFor TP cable connection to another Switch or Hub, verify that only one end of the cable is connected to a “Crossover” port.

II.100BASE-TX port Link LED is lit, Collision LED is blinking, but traffic is irregular.

ØCheck that the attached device is not set to dedicated Full-Duplex. (Some devices use a physical or software switch to change Duplex modes. Auto-Negotiation may not recognize this type of Full-Duplex setting).

16