Intellinet Network Solutions 501705 manual Quick Installation, Hardware Installation

Quick Installation

This chapter will give you brief instructions on how to install the product. In section 2.1, we will configure the hardware part of SA step by step. In section 2.2, we will check whether the IP address of your PC is assigned by DHCP. Once we complete the installation of the SA hardware and checked your PC settings, we will use the web-based management to configure the SA to suit your network environment. In section 2.3, and 2.4, we will review all the software settings. We will configure it to gain access to the Internet. If you need additional help or advanced setting details, please refer to the remaining chapters.

Hardware Installation

Please follow the steps below to install hardware:

1.Get the included Ethernet cable.

Connect one end of it to the ADSL/Cable modem and the other end to the WAN port on the SA.

2.Get another Ethernet cable.

Connect one end of it to the PC or hub and the other end to one of the LAN ports on the SA.

3.Turn the ADSL/Cable modem on. Note: Cable modem users MUST disconnect the cable modem from the wall outlet for at least 2 minutes before turning it on again.

If there are more PCs or hubs to be connected, please repeat step 2.

4.Connect the included power adapter to the power socket on the SA and then plug the power adapter into a wall outlet.

5.Turn on the SA.

If the link LED of the WAN port is not ON, switch the WAN MDI/MDIX switch to the alternate setting.

9

© INTELLINET NETWORK SOLUTIONS