Intellinet Network Solutions 529930, I-ISS-020 Troubleshooting, „ Customizing TCP/IP settings

Page 13

Note:

1Once the Internet Sharing Station has been configured, all of the PCs should be restarted to get the new TCP/IP settings from the Internet Sharing Station.

2After restarting your computer, please make sure your computer has obtained an IP address, DNS and Gateway IP address(192.168.0.254).

„Customizing TCP/IP settings

The Internet Sharing Station is preconfigured for installation on a network that is not set up for TCP/IP. It uses a range of private IP addresses in a range from 192.168.0.1 to 192.168.0.254, with the address of the Internet Sharing Station preset to 192.168.0.254.

If you have already set up the TCP/IP protocol on your network, you can customize the Internet Sharing Station to fit your existing IP policy.

To customize TCP/IP settings for your existing network

1.Configure one of your PCs to be a DHCP client, and restart it, then your PC will obtain an IP address automatically from Internet Sharing Station.

2.From the selected computer, launch web browser and connect to the Internet Sharing Station web page (http://192.168.0.254), if the system on your network already have public IP addresses, set ‘DHCP Server:’ to “Disable”, then click “Save” button.

3.Change the Internet Sharing Station’s IP Address to the address that is valid for your network, then click “Save” button, and then click ‘System Restart’ to restart the Internet Sharing Station.

4.Change the IP address of the selected computer back to its original setting.

5.Make sure the Gateway IP address of all PCs must be same as the Internet Sharing Station’s IP

address, DNS must be enabled, and DNS IP address(es) must be assigned.

Troubleshooting

Troubleshooting gives you solutions to problems that may occur during installation and operation of the Internet Sharing Station.

1. Problem:

No power to the Internet Sharing Station

Possible Cause: The power adapter is a defective one.

Solution:

Check the power cord and power outlet to verify its connection. If it still remains unlit,

 

please replaced another power adapter.

2. Problem:

Can’t connect to the Internet Sharing Station

Solution:

1. Check the TCP/IP setup on your PC.

 

On Windows 95/98: Run winipcfg from Run on the Start menu. The PC should have an

 

IP address of 192.168.0.n, where n is from 1 to 252. The Gateway IP address of the PC

 

must be 192.168.0.254. If the IP address is not in the range, click Release then click

12

Image 13
Contents User’s Manual Introduction FeaturesHardware Introduction Package ContentsConnecting your equipment Install the unitDesktop Installation Magnetic Mounting InstallationConfiguring the Internet Sharing Station Quick Configuration To configure a Windows 95/98 systemTo configure other systems Basic ConfigurationNetwork Configuration Network Settings Advanced ConfigurationsModem Configuration Login Script Configuration Modem AT Command SettingsLogin Script Settings Remote Access Service Configuration Email Sharing ConfigurationConsole Password Configuration Virtual Server ConfigurationReset to Factory Default Firmware Upgrade ProcedureSetting up the other PCs System Restart„ Customizing TCP/IP settings TroubleshootingTo customize TCP/IP settings for your existing network Ipconfig / release Page Regulatory Standards Compliance SpecificationsSafety Compliance CE Mark Declaration of Conformity for EMC and SafetyEECSicherheitshinweise „ Learn the script syntax Appendix a Login Script FilesScript for this scenario Script file used for CompuServePc1 Outlook ExpressPc2 192.168.0.254 Fill in the incoming and outgoing mail server Netscape MessengerFill in aliases name and real email address Select Edit-Preferences-Mail & Newsgroup-Identity Select 192.168.0.254-Edit Eudora 1.5.4 ~Select Tools-Options-Getting Started Tools-Options-Sending Mail Eudora 4.x.x and aboveSelect Tools-Options-General