Intellinet Network Solutions 524957 user manual Hardware Installation, Rear Panel Ports & Jacks

1 HARDWARE INSTALLATION

Using the included RJ45 Ethernet cable (and more, as needed), make your 4-Port Broadband Router network connections by following the steps below and referring to the Port and LED descriptions (presented from left to right).

1.Turn off all devices to be incorporated into the network, including any PCs, switches/hubs, the modem and the router.

2.Connect the LAN or Ethernet network port of the cable/DSL modem to the router’s WAN port.

3.Connect PCs (and any switch/hub used to expand the network) to the router’s LAN ports.

4.Turn on the cable/DSL modem.

5.Use the included power adapter to connect the router to an AC outlet.

6.Turn on the PC you’ll be using to configure the router.

1.1 Rear Panel Ports & Jacks

WAN PC1 PC2 PC3 PC4 Reset PWR

WAN — This 10/100Mbps port connects the cable/DSL modem. PC1-4— These four LAN ports connect networked devices, such as

PCs, print servers and remote hard drives. If you connect a LAN port to a switch or hub, check that both the device’s Power LED and the router’s corresponding PC/LAN LED (see below) light to confirm the connection.

Reset — Push this recessed button to clear all established router configuration settings and reset to the factory default settings. See Section 3: Restore Defaults.

PWR — This jack is for the included external 9 V DC, 500 mA power adapter.

4HARDWARE INSTALLATION