Hypertec FastPrint Multiprotocol Ethernet/Fast Ethernet Print Server Hardware manual 110 mm

Page 16

To mount the HyperNet Fastprint with the front panel facing up (and the printer port connectors facing down), set the two mounting screws at the lower-left and upper-right corners of a rectangle as shown below (actual size):

110 mm

4 5/16 in

70 mm

2 3/4 in

When setting the screws into the wall or partition, leave about 3 mm (1/8 in) between the head of each screw and the wall surface. Then place the HyperNet Fastprint so that the mounting sockets on the bottom of its case fit over the two screws. Press the case gently toward the wall and slide the case

Index

Image 16

Contents Multiprotocol Ethernet/Fast Ethernet Print Server Page FCC Warning Page Port Pinouts Index Vii Page Print Server Features External Features AppleTalk MacOS EtherTalkNetwork Cable Connector LPT1, LPT2, COM Installing the HyperNet Fastprint ServerPower On Self-Test Testing Your HyperNet Fastprint Contact your dealer for correction of the faulty unit110 mm Index Network Connection Network ProtocolsPort Pinouts Serial Port Index Ph +44 01488 LPT1