Hawking Technology 100M, 10M manual Access the Switch, Console Port Out-of-band connection

This section instructs you on how to enter and set up the configurations, which can be accessed by RS-232 serial port (out-of-band) on the rear panel or by Telnet session / Internet Browser over the network (in-band).

Factory Default value:

IP: 192.168.1.1

Subnet Mask: 255.255.255.0

Default Gateway: 192.168.1.254

4.1 Access the Switch

Console Port (Out-of-band) connection

The operating mode of the console port is:

•DCE

•115200 (Fixed baud rate)

•n (No parity checking)

•8 (8 Data bits)

•1 (1 stop bit)

•None (No flow control)

After attaching the RS-232 cable (Straight-through) to the serial port of a PC running a terminal emulation program, press the “Enter” key. A login screen will then appear. Enter your username and password to log into the management console.

Note:

The management functions of the console program are exactly the same as the web-based management interface but in text mode.

Attention: 1. The factory default User Name and Password are both “admin”.

2.System configurations via the Console Port will only be allowed by way of the master device.

11