Wireless Add-on Switch
Model 6133
Your wireless
• 1 transmitter wall switch unit
• 1 receiver wall switch unit
• 2 wire connectors
• 2 #8 x 2" wood screws
You'll need to buy a
Multiple channels (A thru E) are available so that you can operate several systems at different locations in your home. If you purchase more than one system, make sure you select different operating channels, or they will interact with each other.
If you purchase a different switch plate to match your decor, make sure it is not a metal plate. Metal wall plates will reduce the operating range.
IMPORTANT: Use only as a second switch to remotely control a light. Do not use if more than one switch exists.
Installation
1.Select a wall switch location that controls a light or overhead incandescent light. Keep the following points in mind while selecting a location:
•Never install two receiver units within 3 feet (0.9 m) of each other or it could reduce the operating range.
•The total lighting load must not exceed 500 watts (incandescent only).
•The receiver must be located within the range of the transmitter (up to 100 feet [30 m]) in the room or hallway that they are installed so they will oper- ate properly.
•Make sure that large metal objects are not located between the transmitter and receiver since it could interfere with the signals.
2.Turn off the power to the light switch circuit before you proceed. Do this at your circuit breaker or fuse box.
© 2007 HeathCo LLC |