Setting and Using the Alarms

Using the iBN180

This unit has 2 separate alarms, each set the same way. Below we explain how to set Alarm 1. To set alarm 2, follow the same steps using the Alarm 2 Button.

Note: each step must be completed while display is flashing or step will time-out with any changes saved.

1.	Press and hold the Alarm 1 Button for 2 seconds until the time display and alarm icon flash.
2.	Press the – or +	Buttons to adjust the alarm time to the desired time (hold for rapid setting).
	Make sure you set the correct AM/PM alarm time. The AM and PM indicators appear on the left of the
	display.
3.	Press the Alarm 1 Button to confirm the alarm time setting. The wake-to source will flash.
4.	Press the – or +	Buttons to select the desired wake to alarm source: Bluetooth, radio or tone.
Wake to Bluetooth:		You will wake to the currently linked Bluetooth device. If no device is detected, the
		alarm will default to current Tone.
Wake to Radio:		Press the Alarm 1 Button to confirm. Press the	Presets Button to select an FM
		preset to wake to, or press the – or + Buttons to tune in a desired wake to
		station.	– or + Buttons to select one of the
Wake to Tone:		Press the Alarm 1 Button to confirm. Press the	– or + Buttons to select one of the
		four built-in wake-to tones.

5.Press the Alarm 1 Button to confirm the alarm source. The volume display will flash.

6.Press the or Buttons to adjust the alarm volume on the unit from 05 - 40. Note that the alarm volume setting is stored separately from other volume settings.

7.Press the Alarm 1 Button to confirm the alarm settings and exit alarm setting mode. 2 beeps will confirm clock setting is complete. The alarm icon will remain on the display, indicating the alarm is armed.