Important Note about 3-WAY Circuits

Things to consider regarding RF range:

•Each wall or obstacle (i.e.: refrigerator, big screen TV, etc.) between the remote or Z-Wave device and the destination device will reduce the maximum range by approximately 25-30%.

•Brick, tile or concrete walls block more of the RF signal than walls made of wooden studs and plasterboard (drywall).

•Wall mounted Z-Wave devices installed in metal junction boxes may suffer a significant loss of range (approximately 20%) since the metal box blocks a large part of the RF signal.

Effects of Home Construction on Wireless Range Between Z-Wave Enabled Devices

Note: The distances shown in the table below are typical examples. Actual performance in your home will vary.

From the Remote (or repeating Z-Wave module) to destination device:

Type of		Wood Frame with		Brick, Tile or
Construction		Drywall		Concrete

		Plastic	Metal	Plastic	Metal
		J-Boxes*	J-Boxes	J-Boxes*	J-Boxes
Number of	0**	100’	80’	100’	80’
Walls or	1	70’	56’	60’	48’
Obstacles	1	70’	56’	60’	48’
Obstacles	2	49’	39’	36’	29’
	2	49’	39’	36’	29’
	3	34’	27’	21’	17’

*For Plug-in Modules or In-Wall Devices Installed in Plastic Junction Boxes ** Line of Sight / no obstructions

Please Note: Z-Wave home control networks are designed to work properly alongside 802.11 wireless computer networks, Bluetooth and other 2.4GHz or 5.8GHz devices. Some baby cams, wireless video devices and older cordless phones using the 900MHz frequency range may cause interference and limit Z-Wave functionality. Many 900MHz products have a switch to select channel “A” or “B”. You may find that one of these channels will cause less interference than the other.

The term “3-way circuit” refers to a circuit with two switches and one load (light) like you find at the top and bottom of a stairway. There are many ways to physically wire a 3-way circuit and it is important to understand how the circuit you wish to upgrade to Z-Wave control is wired. Below is a description of a typical 3-way circuit.