Sender Panel Descriptions, Hdmi Input Port

SENDER PANEL DESCRIPTIONS

1Locking 5V DC Power Supply Input

Connect the included 5V DC power supply to this input port.

2HDMI Input Port

Connect the HDMI source device to this input port. A secure connection to this HDMI port can be made using Gefen Mono•LOK cables.

3IR Out Port

An IR emitter/blaster (sold separately, part# EXT-2IREMIT) must be connected to this port to use the IR Repeater feature. Connect the emitter to this output port and then connect the emitter “eye” on or near the IR receiver of the equipment that is intended for control.

4Link LED Indicator

This LED indicator will become active once a valid link has been established between the sending and receiving units. If this LED does not activate there is a possible mis-connection between the two units.

5Red BNC Connector

This connector will transmit the RED signal data to the receiving unit. The cable used for this connection cannot be omitted.

6Green BNC Connector

This connector will transmit the GREEN signal data to the receiving unit. The cable used for this connection cannot be omitted.

7Blue BNC Connector

This connector will transmit the Blue signal data to the receiving unit. The cable used for this connection cannot be omitted.

8Clock BNC Connector

This connector will transmit the CLOCK signal data to the receiving unit. The cable used for this connection cannot be omitted.

9Receiver Power BNC Connector

This connector will transmit the power needed to operate the receiving unit. The cable used for this connection can be omitted when using a 4 BNC type of cable setup. If this cable is omitted power must separately be supplied to the receiver by one of the included 5V DC power adapters.